Articulating Speaker Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Multi-direction articulating speaker wall mount. Originally designed for attaching Vizio mounting cube, but extensible.
- Ocena
- 0 / 5
- Polubienia
- 65
- Pobrania
- 472
- Wydruki
- 2
- Wyświetlenia
- 2518
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
Created for my Vizio soundbar surround rear speakers, with index holes for the dots that are on that speaker cube/mount. However, this could be used for other speakers attaching an appropriate interface to this.
Printing:
I printed in the orientation shown in the images with build plate supports, but it should print fine without supports if you print the mid hinge on it's top/bottom orientation.
I used PLA w/ 15% infill.
Optionally, I did fuzzy skin @ 0.1 thick / 0.15 point distance, on all but the knob & cap, to give it a less 3D printed look.
Hardware needed:
- 2x ¼-20 bolts @ 2" length
- 2x ¼-20 nuts
- 2x washers
- 2x pan-head screws for mounting to wall (drywall/concrete anchors may be needed)
- 1x M4x10MM pan head bolt to attach the speaker mount cube
- I used a M4 tap to tap the hole. A heat insert or screw from behind the “interface” part may be needed if you speakers are larger/heavier.
Assembly:
- Ream & tap thread onto “Speaker interface” part
- Attach speaker mount/cube onto Interface w/ M4 bolt
- Insert bolt into knurled knob, open side toward bolt head
- Place cap on knob
- Add washer to bolt
- Insert nuts into hinge parts
- Assemble remainder as seen in photos
If you make or remix, I'd love to see it, so please tag/upload. Enjoy