M-Lok rail flashlight attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An M-Lok rail attachment for a flashlight or other 25mm diameter round accessory
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 306
- Wydruki
- 1
- Wyświetlenia
- 925
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
An M-Lok attachment for a flashlight or any round accessory for your rifle. This works for a flashlight which is about 25mm in diameter (close to 1"), but can probably be modified to fit other sizes.
Required hardware:
- standard M-Lok screws and nuts (such as https://www.amazon.com/Magpul-M-LOK-T-Nut-Replacement-Set/dp/B00PDKOC4W) to attach to the rail. The M-Lok screw head should be up to 10mm in diameter and about 2mm in thickness. Typically these have an 1/8" hex driver key.
- 4 M3x20mm hex screws
- 4 M3 nuts
Print using ASA, ABS or PETG. It is recommended to use 3 or more perimeter lines and 30% or more infill for extra strength.
Support can be avoided entirely if printing according to the attached screenshot - with the M-Lok attachment part in normal orientation and the clamp part standing up.
The M-Lok screw holes include a sacrificial layer that allows printing the screw holes without support - this should be punched though and cleaned up after printing.