1 / 4
Pusi Negotiator for xBloom Studio Omni Dripper 2 (unofficial)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Negotiator for wave filters on the xBloom Studio Omni Dripper 2. Unofficial design.
- Ocena
- 5 / 5
- Polubienia
- 46
- Pobrania
- 1085
- Wydruki
- 2
- Wyświetlenia
- 5339
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (1)Kolekcje (62)Powiązane
This is the Pusi Negotiator.
An unofficially designed negotiator for wave filters to be used on the xBloom Studio Omni Dripper 2.
Brewing note: I recommend either this recipe designed by @pradyboy for Moodtrap beans, for use with this negotiator:
Grind size: 67 @60rpm - https://share-h5.xbloom.com/?id=H0ziqjcH5%2BHAL7qcz0dpWA%3D%3D
Note on nomenclature: Pusi (푸시) is the Korean word for PUSH. Thanks to EAF member @heytchap for the name.
Printing tips:
- Use the STEP file if you can instead of the STL (more reliable for slicing, but both included for convenience).
- There are some chamfers so its best to use low layer height 0.16mm or lower for visuals, but go nuts with layer height if you don't care about looks.
- Recommend PETG if you use hot water to rinse filters, otherwise PLA/PLA+ is fine.
- Extra walls and higher infill recommended (but not needed) to give a more solid feel to the shaft / handle.
- You may also want to print with ironing on top layer for a nicer finish.
- No supports needed, just print flat on the bottom.