Hydroponic stirrer and pump wall mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for a magnetic stirrer with a mason jar and a peristaltic pump
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
I want to wall mount chemicals next to my hydroponic setup along with some small pumps to automatically control PH (and eventually EC).
I designed the attached parts to be held to a board with 2 screws each.
Printed in Polymaker Polylite ASA (natural) on a P1S. Recommend ASA or ABS for UV/Heat/Chemical resistance.
Note: The tabs on the vertical tube are fragile but I have what I need working, so not updating them at the moment - if you are careful, they install fine - just take care if you ever need to remove them (you should not need to). If they break, I recommend just gluing the tube to the lid.
Reminder - cover the mason jar in foil to avoid light exposure.
Parts used:
https://www.amazon.com/Kamoer-Peristaltic-Hydroponics-Nutrient-Analytical/dp/B07GWJ78FN
2x M3 screws and nylock nuts to mount pumps (length depends on your exact setup)
4x Washer head screws to mount to wall (I used Kreg pocket-hole screws because I have tons of them)
Step and Fusion360 files provided if you want to tinker with the design.