1 / 4
Zebra F refill to Fisher pen adapter — zdjęcie 1
1 / 4

Zebra F refill to Fisher pen adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adapter for Zebra F refills to be used in click pens that use the Fisher PR-4 refill.

Ocena
0 / 5
Polubienia
6
Pobrania
33
Wydruki
0
Wyświetlenia
428
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Share Alike

About

This is for Fisher, Rite-In-The-Rain, and other retractable ballpoint pens that are designed to use a PR4 refill. I don't know if is needed in non-retractable pens like the Fisher Bullet pen. Without the adapter, Zebra F refills sit too low in the pen barrel (see second picture) which weakens the click and causes the pen to rattle when retracted. With the adapter, the top of the refill sits higher in the pen barrel (see third picture), and applies the correct spring tension. There is a slight taper in the inside diameter to accommodate the tapered neck of the Zebra F refill. It works with both the plastic and metal Zebra F refills. Tested with a Fisher Cap-O-Matic.

Installation

  1. Take off the spring from the Zebra F refill.

  2. Slide the adapter over the tip of the refill down to the base. Note that there is a taper on the inside, so if it does not go down all the way like the cover photo, try flipping it around.

  3. Install it in your pen as you would a PR4 refill.

Printing

Printing with a brim might be helpful for increased bed adhesion. Too small for infill. No supports needed. The taper will be ‘wide side up’ when printed in its original orientation.

Tagi