Manta M8P Driver CB1/CM4 Cooling Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed version to extend legs so the cooler bracket will clear the stepper driver heat sinks.
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 221
- Wydruki
- 0
- Wyświetlenia
- 1450
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Print Settings
First Layer Height: 0.25mm
Layer Height: 0.2mm
Extrusion Width: 0.4mm, forced
Infill Percentage: 40%
Infill Type: Adative Cubic, Grid, Gyroid, Honeycomb, Triangle, Cubic
Wall Count: 4
Solid Top/Bottom Layers: 4
Seam Placement: Rear
Supports: None
Hardware:
4010 Fans x 4
M3X5X4 Heatsets x 19 (16pcs for Fans, 3 for Legs)
M2.5x10mm SCHS x 4 (CB1/CM4 Heat Sink)
M3X10mm SCHS x 4 (M8P to DIN CLIPS)
Note: The screw lengths are a close guess, it would prob be better to order a kit with multiple-length screws. I will update them once I have it mounted.
Instructions
The M3 screws pass from underneath the board through the DIN clips and into the legs of the fan bracket. You may have to drill through the DIN clips with a 3mm drill bit so the screws an pass through.
Update 6/11/24
I printed and tested the first version with my M8P v2.0 and some TMC 2240 drivers. It didn't quite clear the heatsink's on the 2240s. I extended the legs by another 4mm in v2. I will reprint this and try it with the increased leg length.