MMU3 Buffer segmenter-R4 with side holes, reinforced
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of segmenter-R4.stl. MMU3 Buffer can be mounted on the side of the Prusa Enclosure with one screw.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 727
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
This model lets you mount the MMU3 Buffer on the side of the Prusa Enclosure like a wall clock. Prusa Enclosure has numerous holes on the side and the back, so it can be mounted on one of them.
Since the original "segmenter-R4.stl" part was thin, it would sag when suspended only by one side. So I made some modifications.
- Overall thickness of the part was increased by 8mm.
- Thickness was increased by 4mm on the side of the screw hole.
- Screw hole was elevated by 2.5mm to avoid contact with the pre-installed M4x5r screw on the enclosure.
Requires:
- Five M3nS (square nuts)
- One M3x8 screw
An ordinary M3x8 screw can be used. However, tightening the screw would be quite a challenge if you are planning to mount the buffer close to the rear of the enclosure. I recommend using the M3x8 thumb screw which comes with the “Quick release PSU cable”.
The "segmenter-R4 sidehole.stl" file is a single color print file.
The "segmenter-R4 sidehole, 2colors, Prusaslicer.3mf" file is, as the file name says, a two color multicolor print, exported from Prusaslicer. The letters are merged.