Home Assistant Voice Satellite Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here is an enclosure for a Home Assistant satellite using a Raspberry Pi Zero W 2 ***UPDATE: V2 version uploaded.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 1825
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
UPDATED V2
Lid: removed unnecessary mic “slots”, rotated snap closure to raise from the back first (allows speaker magnet to clear circuit board)
Case: rotated snap closure to match lid
LED lens: adjusted size (adjust X-Y contour for good fit on your printer)
Speaker bracket: no changes
----------------
This enclosure holds a Raspberry Pi Zero 2 W with a ReSpeaker 2mic hat and a 40mm speaker. It is based on the tutorial on the wyoming-satellite github here:
https://github.com/rhasspy/wyoming-satellite/blob/master/docs/tutorial_2mic.md
The 40mm speaker can be found here:
https://www.adafruit.com/product/3968
Since the speaker has no screw holes, I was going to glue it to the speaker bracket, but the bracket held it in place well enough on a test fitting that I don't think it's necessary.
The opening in the side for USB fits the official Raspberry Pi micro-USB plug, but might need to be resized for any other brand USB plug. I recommend plugging this in before putting the lid on so you can hold the 2 mic hat in place while connecting.
Screws are 2.5mm
Printed everything in opaque PLA except the lens which is clear PLA. Glue the lens in from under the lid so it's flush with the top. (photo shows it glued in from the top)
Feedback welcome.