1 / 5
TTRPG Fog machine from GeekVape Z Subohm Tank — zdjęcie 1
1 / 5

TTRPG Fog machine from GeekVape Z Subohm Tank

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

All parts needed to create a mini fog-machine for your tabletop terrain

Ocena
0 / 5
Polubienia
14
Pobrania
28
Wydruki
0
Wyświetlenia
619
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Disclaimer:  this one comes without any warranty, you will have to know what you're doing, I can not be held responsible for any harm to persons or material. Currents greater than 15Amp. will flow in this setup, bearing the risk of fire and injury. 

 

To build this small fog machine you will need the following parts:

  • 1 GeekVape Z Subohm Tank
  • 1 GeekVape Z coil (0.4 Ohms)
  • 1 mini air pump (link)
  • 1 (or more) battery 18650 3,7V high drain (mine is 20A)
  • hose with an outer diameter of 9mm
  • 1 M8 nut
  • wires (keep in mind the circuit might run up to 20 Ampere!)
  • Fog fluid (maybe thinned down with ~10% distilled water) or vaping base or glycerine (also maybe thinned down)

Optional:

  • 1 Arduino nano for interval control
  • mosfet module (matching the maximum current in your circuit) (I used one of these)
  • DC-DC step-up Boost converter (like these)
  • switches / momentary switches
  • a charging module for the battery (like these)
     

Building:
remove the air flow control ring from the tank (by removing the upper cap just like if you would refill the tank) and replace it with the “Air intake”. 

  • Note that there is a notch on the part to assure it sits correctly over one of the air intake slots of the tank
  • Solder one wire of sufficient diameter to the outside of the M8 nut and screw it onto the connector of the tank (this will be the negative connection).
  • Solder one wire of sufficient diameter to the copper pin in the middle of the connector (this will be the positive connection)
  • attach the air pump to the connector of the “Air intake”. I used a short piece of my hose to make it tight
  • complete the circuit as per your needs, I attached a wiring diagram of how I did it

optional:

  • If you want the hose to be at a 90° angle from the tank, remove the drip tip and replace it with “Outlet_90deg”

 

Apart from the “Condensate_Catcher_Lid*” and the “Air intake”, all parts print without support, you might need to flip some, though.

 

I added an arduino to my project which is having a connection to a switch. If that one is closed, the arduino will trigger the mosfet for 3 seconds, followed by a pause of 3 seconds in order not to overheat the coil.

Arduino code is available on the files section as an example.

 

 

 

Tagi