1 / 3
Center Differential for EXPLORER-MK1 3D PRINTED 1:10 RC CHASSIS
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wanted to remove the back and forth play of the driven gear and decided to turn it into a center differential.
- Ocena
- 0 / 5
- Polubienia
- 46
- Pobrania
- 169
- Wydruki
- 0
- Wyświetlenia
- 1605
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (13)Wydruki i komentarze (Wydruki: 0) (Komentarze: 5)Remiksy (0)Kolekcje (66)Powiązane
Notes:
- I can not recommend PLA for this. It started deforming during torture testing with a drill.
- Every surface that moves and touches another surface should be greased.
- The differential cover should go towards the back of the car.
- The axle shafts differ slightly. The rear one is marked on the end to tell them apart.
- There should be no play between the axle shafts and the diff housing.
- The differential should run smooth without stuttering after turning it a few times by hand.
- This also removes the need to print the gears with supports.
- The attached images explain the assembly.
BOM:
- 1x M3 18mm pin, threaded rod or bolt cut to length
- 2x M3 16mm countersunk screw
- 2x M3 8mm countersunk screw (20mm for optional axle shaft)
Print Settings:
- Filament: PETG
- Layer Height: 0.2mm
- Infill: 100%
- Supports: no
"Happy printing, and God bless, my friend."
— Bob Ross