Washer for Rockler Hold Down Clamp and Bridge City Tools Jointmaker Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Washer for Rockler hold down clamp and Bridge City Tools Jointmaker Pro
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
NOTE: Please honor and adhere to the license of this model. Commercial use is prohibited and not allowed.
Although this part was designed specifically for a Rockler hold down clam and a Bridge City Tools Jointmaker Pro, it probably can be used with any T-bolt and track system where the T-bolt goes through the track.
The washer was designed to be used with a Rocker hold down clamp (https://www.rockler.com/rockler-bit-saver-hold-down-clamps-5-1-2l-x-1-1-4w-2-pack) and a Bridge City Tools Jointmaker Pro (https://bridgecitytools.com/products/jmpv2-jointmaker-pro).
“Out of the box”, the clamp can be used with the bed of the Jointmaker Pro, but attaching and removing requires the nut and all of the components of the clamp to be removed in order to pull down the bolt and remove the clamp.
I designed a washer to fit on top of the T-bolt, allowing the clamp to remain assembled, even when removed. (thus removing the need of having to unscrew and disassemble everything)
First, print the models. The “washer” comes in two parts - the washer and an alignment guide. I split the model in to two pieces to make it easier to print and to be able to print without needing supports. Both parts have two hole - each are 2mm wide and accept short pieces of 1.75mm filament. To assemble, cut off two short strips of filament and then glue everything together (I used E6000).
Next, grind down or file the sides of the T-bolt, so the width of the head is the same as the diameter of the threads. The T-bolts are aluminum, so they are easy to grind down using either a grinder or a file. Here are two before and after pictures:


After both sides of the head of the T-bolt have been grinned down, assemble the clamp and then insert the T-bolt through the slot on the bed:

Next, place the washer over the T-bolt:

Then pull up…

And now it's ready to use…

When you want to remove the clamp, simply loosen the nut at the top, reach underneath, remove the washer, and then pull up.