OpenRC F1 Rear suspension extra clearance for TrackStar Sensored Brushless Motor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Since I have the Trackstar 21.5T Sensored Brushless motor I needed more clearance for the motor to be mounted. so I…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 597
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Since I have the Trackstar 21.5T Sensored Brushless motor I needed more clearance for the motor to be mounted. so I added some clearance by editing the left holder like Drazen had done with an exacto knife.
this part works now perfectly with my motor and F1.
You might need to shave a bit of plastic of the pressure plate with exacto knife to get the motor mounted nicely since the A-terminal of the motor might hit it, Depending how you have soldered the cables. Also you should reprint the pressure plate in 100% if you havent done so already.
PSA! With the trackstar engine you need to use Drazens Rear Suspension Engine Cover! PSA! https://www.thingiverse.com/thing:2154827
Since I got a few questions where I got the keystones from since the original link is dead, I ordered them from Digikey: https://www.digikey.fi/product-detail/en/keystone-electronics/5220/36-5220-ND/2745879
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
No
Supports:
No
0.2
Infill:
100%
Filament:
doesnt matter pla doesnt matter
Category: R/C Vehicles