Mytee Eco-17 Cord lock holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I got tired of the stock cord lock not fitting the machine side and falling off. Heres my solution.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 1
- Wyświetlenia
- 348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
I got tired of the stock cord lock not fitting the machine side and falling off. Heres my solution, i took a picture of the one that came with it and made width changes in fusion 360. I added a circle cutout on each end so the cords set firmly inside without falling off every few mins. It is slightly wavy on the machine side so that if it does come out of its hole it is not a straight slide out and hopefully helps it stay in better.
There are 3 versions available, 1 is blank, one has text debossed into the surface and the other one has the top text raised by .4mm to allow a color change above 10mm.
In the slicer for the bridging make sure the angle is set properly and you wont need any supports, I used 45 degrees. printed with 4 walls 0.2 layers and 20% infill PetG