Vanishing Point/Majohn Ax Ballpoint Converter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is dumb. It's a sleeve that you can put a 3mm ballpoint cartridge in to use with a Pilot VP or a Majohn A1/2/3.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 211
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an adapter/sleeve thingy which allows you to use a generic 3mm ballpoint cartridge in an otherwise perfectly fine Pilot Vanishing Point or Majohn A1/2/3.
NOTE
I don't really recommend using this on a pen you care about a lot. The tip of the ballpoint will contact the trapdoor directly and will mark it up. The set up for the cartridge could also cause the cartridge to leak and completely mess up your pen. USE THIS WITH CAUTION.
Required Equipment and Materials
- 3mm ballpoint cartridge (usually found in cheap ballpoints)
- Side cutters (if the cartridge is from a clicker pen)
- Possibly sandpaper and other abrasives
Print Settings
I printed this on my resin printer, however FDM should also work
- 50-100% infill (won't affect time and material use by much)
- 0.20mm layers max
- Brim
- Supports (improves bed adhesion)
Assembly
If the cartridge is from a clicker pen, cut off the fins which the spring rests on (if it exists). Be VERY carful to not cut through the plastic as ink WILL leak out.
Insert the cartridge into the adapter and glue if necessary.