Troodon 2.0 Pro - 7.5mm Breakout Board / Z-Chain Reducer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacers for the breakout board to sink it further into the base to give a bit of clearance for routing extra cables.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 250
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I have not used this or tested it myself - this is just an idea that I came up with. Use at your own discretion for your own needs!
The connectors on the breakout board occupy most of the available space in the cutout located underneath the Z chain in the back of the printer. These spacers add a bit of clearance to allow for cables up to 6.5mm to be slipped behind the molex connectors on the board. Simply install between the breakout board and the mounting points underneath the printer.
Since this means the Z chain cables would no longer reach the board, I have also reduced the height of the bracket to lower it closer to the board.
You will need to replace the mounting screws with M3x12 screws to reach the mounting points with the spacers installed.