1 / 4
Badge Holder with Yubikey with tighter tolerances and holes for key visibility. — zdjęcie 1
1 / 4

Badge Holder with Yubikey with tighter tolerances and holes for key visibility.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Re-Remix of "Badge Holder with Yubikey no supports" by niode now with tighter tolerances and holes for key visibility.

Ocena
0 / 5
Polubienia
10
Pobrania
76
Wydruki
0
Wyświetlenia
671
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I am quite happy with this current version. The changes work well and the card doesn't rattle around like crazy anymore.

If you use your card for NFC card readers the Yubikey's NFC chip might mess with the reader because both the card and the Yubikey are being read at the same time. Fortunately the NFC on the Yubikey is weaker than my card so it mostly works out but on some readers it works poorly.

My solution that appears to work fairly well is putting some aluminium tape on the underside of the card that's directly over the Yubikey. I assume most don't own aluminium tape, so you could also try taping some normal aluminium foil to the card but it's probably quite hard to make it look nice.

I recommend a fairly high infill ratio.

Tagi