TWO TREES TTS-55 basic care package
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
support for cable chains holders for limit switches 2.5cm higher legs(for clearance)
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 90
- Wydruki
- 1
- Wyświetlenia
- 643
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Basic care package for TTS55
what do you need:
20x10 openable cable chain for Y axis - you will need 65cm
10x10 for for X, laser cable will fit with connector - you will need 50cm
2x creality ender limit switches with 1m cable !!! i had to switch S and V cables on mine. if your limit switches disconnects board on switching, you need to do this too. Just take original connector, stick something sharp to secure tongue on pin down and pull the cable with pin out.
1x M5x15mm bolt with nut that goes into profile to secure Y limit switch holder in place.
Some epoxy glue for gluing X chain support together and in place
some small screws for securing cable chains, you will need to predrill holes for X axis chain
Legs are based on this model
https://www.printables.com/model/698345-leg-two-trees-tts-55-150mm