Lcsoft CY7C68013A Mini Board Dev Kit Logic Analyzer Probe Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed Case for LCSOFT CY7C68013A logic analyzer clone" by jamesglanville I edited OpenSCAD to remove switch and…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Remixed Case for LCSOFT CY7C68013A logic analyzer clone" by jamesglanville
I edited OpenSCAD to remove switch and screw holes, friction fit was tight enough. (set to 0 size to remove)
edited screw to allow to use counter sunk screws. added comments to make editing easier.
Added Probe Case to hold protection buffering PCB for 16 probe and 2 grounds.
Added ribs to hold PCB
I used 470R resistor in series with probes (100R to 512R could be used) and protection diodes to VCC / GND (CM1293A-04 or DVIULC6-4SC6 or USBLC6-4SC6 or 1N4148) mounted on Perforated PCB
Another option for protection is using 74LVC245 or TXS0108E IC's and protection diodes.
More info about open source Logic Analyzers and Software can be found at https://sigrok.org
Print Settings
Printer:
Geeetech E3D V6
Rafts:
No
Supports:
No
Resolution:
0.28mm or less
Infill:
1%
Filament: Generic PETG, PLA, PLA-F White
Notes:
Print with 4 walls for strength
Category: Electronics