Barbeque cover clip with new V2 version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clips a cover to the leg of barbeque with 25mm legs so the wind doesn't blow it away.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Clips will hold the barbeque cover on, even in moderate wind. The slots have a small bump to ensure clip stays closed. The 3MF is configured with eSun ePLA-st, but I also print these in ASA without interface support material and they come out fine.
Edit: November 24. I upgraded the design. After a rather wild and windy winter, the clips largely held on, but a couple cracked around the inner edge and one spread a little. I beefed up the design by doubling the inner thickness, thus adding 4mm to the total width of the shell and thickened the clips to suit. They should stand a good beating now. They are harder to assemble as I didn't thin the backs of the clips down, but they are much less likely also to come apart accidentally. Both versions are still here.