Triumph Daytona 600 (2004-2006) Bar End adaptor for 22mm Front Brake Guard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Taking your Triumph Daytona 600 on the track you will need a Front Brake Guard - this bar end replaces the original one
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I have a 2004 Triumph Daytona 600. I needed to fit a FRONT brake guard so I can take it on the track. I bought several CLIP ONs but they are all 22mm. My original bar ends are 27mm. Rather than mill the original down I created these 27mm to 22mm Triumph Daytona Bar Ends for 22mm Brake Guards. Just unscrew the original brake guard and screw this 3D printed one in place. It's best if you can fit a RUBBER washer between the end of the handlebar and the 3D printed bar end - stops it turning round. If you can't find one - cut an old inner tube in to a 25mm diameter circle and put a hole in the middle. Thank you.
PROBLEM - 27mm bar end

SOLUTION - 27mm to 22mm Bar End Adapator

