Simple RG405M Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simplified remix of the RG405M Case to remove branding and use the original packaging insert to protect the face.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 347
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a slim snap case for an RG405M to help it travel better inside a bag.
It's intended to re-use the original packaging foam piece to protect the front face. Place the RG405m in the case, place the foam piece on top and apply a couple pieces of double stick tape, then close the case and apply just a tiny bit of pressure and the foam should stick in place to the top for a perfect fit.
Thread some filament through the edges and give the ends a little melt to keep it in place.
I removed some of the branding from the original model as well to make it a little simpler looking.
I printed it in PETG with a 0.2mm layer height and it fits well.
I included the blender files I used when modifying them. They're not perfect. If someone wants to clean up the meshes to make them pristine, I'd happily take the improvement.