1 / 5
Gravity phone holder for rear seat car passengers — zdjęcie 1
1 / 5

Gravity phone holder for rear seat car passengers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Universal phone holder for rear seat car passengers a.k.a. kids. Is easy operability by the front passenger.

Ocena
0 / 5
Polubienia
12
Pobrania
113
Wydruki
0
Wyświetlenia
591
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Universal phone holder for rear seat car passengers a.k.a. kids. Main point of design is easy operability by the front seat passenger (parent). Holder arms will grip phone sides simply by putting phone on the holder and free it when phone is lifted.

Applicable cars

  • cars, with front seats equipped with head rests located on rods with 14mm diameter (or any other position after redesigning beam part of assembly)

Apllicable phones

  • landscape only
  • min. dimensions: 120x55x6 mm
  • max. dimensions: 170x70x15 mm

Features

  • universal phone dimensions supported
  • 2 degrees of freedom adjustability
  • fully customizable on OnShape 
    • Global variables table allows for simple parametric adjustment if only minor changes are needed
  • parts shape and print orientation is optimized for layer strength maximum utilization
  • no supports, no brim, no screws, no glue
  • minimalistic grab mechanism (no gears, one part & one rotating hinge for vertical=>horizontal force transfer)
  • arms do auto-open on phone lift, if arm hinges are loose enough and not in folded position

Assembly

  • orient the Back part so that flat side faces you
  • orient the Arms so they are facing you, toes inward, long toe is up and rotated into folded position
  • snap Arms to the back of the Back part and rotate them into open position
  • slide Back on the Joint grove, where grove stop-point is at the bottom
  • snap Joint to the Beam, which is facing it's teeth downwards

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 v2

Rafts:

No

Supports: 

No

Resolution:

0.4mm nozzle, 0.2 mm layer height

Infill: 

15%, though I've used 100% for Back clamps & Beam hook section using modifiers

Filament: Gembird PLA

black 
 

Notes:

 

Parts are designed and prepositioned for print in the way they execute maximum strenght & require no supports, brims or rafts.

If your print bed adhesion is low or you use warping material, do anchor arm open ends.

Contact surfaces use #spacing_free=0.2 mm spacing.

 

 

 

Category: Mobile Phone

Tagi