Qidi Q1 Pro - Mount for the Nevermore V6

In order to improve the Qidi Q1 Pro handling of Volatile Organic Compounds (VOCs),
a chamber circulation fan which doesn't blow out the air, makes sense.

Since the Nevermore is a beloved air filter for this use, I designed a mount that replaces the exhaust fan with the nevermore.

This bracket is meant for the Nevermore V6 using two 5015 blowers.

For building the Nevermore V6, please consult the Nevermore GitHubn-Page:
https://github.com/nevermore3d/Nevermore_Micro

Materials:

• 2x M3x4x5 heat set inserts
• 1x M3x12 screw
• 1x M3x16 screw

For extending the wire:

• 2x JST-XH 2-Pin (male)
• two wires, about 25cm in length (I used AWG 26) 

Printing:

• Use heat-resistant filament. I used ABS.
• Tested with: 3 Walls, 35% gyroid infill
• No support, break-away support is already in the model file

Assembly:

1. Break away the supports and clean the scars.
    
2. Insert the heat set inserts with a soldering iron in the inside of the “arms”.
   
    
3. Glue the exhaust cover on the mount, aligning the screw holes and the cable canal.
    
4. Prepare the extension cable by installing the JST-XH 2-Pins.
   Make sure the polarity of your Nevermore built will match the one from the board of the Q1 Pro.
   

Installation:

1. Plug the extension cable into the nevermore (make sure the wire polarity is correct).
    
2. Push the Nevermore V6 into the bracket while routing the wire through tha canal.
    
3. Use the M3x16 screw and the M3x12 screw to connect the Nevermore V6 with the frame.
    
4. Screw the assembly into the exhaust hole, using the original screws, 
   while running the cable through the canal.
   
    
5. Plug in the cable into the exhaust FAN0 connector (blue).