Hörmann remote control holder (HSE 4 BS & HSE 2 BS) (HSE 1 BS not tested)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fairly simply Hörmann remote control holder. It fits - HSE 4 BS - HSE 2 BS Yet I am not sure if also HSE 1 BS.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 67
- Wydruki
- 0
- Wyświetlenia
- 627
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For my second remote control, I was missing a holder to mount with double-sided tape in my car, so I made one.
In the photos, you can see a tiny gap between the remote control and the case. I didn't want it to be too tight, as I plan to remove it daily.
I used Prusament Jet Black PETG with a 0.25 mm nozzle and a 0.15 mm layer height. However, a 0.4 mm nozzle and a 0.2 mm layer height should work fine, and you can use PLA as well.
This holder fits:
- HSE 4 BS
- HSE 2 BS
I have not tested it with HSE 1 BS, so I cannot confirm compatibility, yet I think it is compatible.
There are two models available: one with a curved back and one with a flat back for mounting on a flat surface. There is no need for supports for either model.