1 / 4
ESP32-CAM Mount for Prusa XL EnXLosure, with vents and USB-C compatible — zdjęcie 1
1 / 4

ESP32-CAM Mount for Prusa XL EnXLosure, with vents and USB-C compatible

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Install a ESP32 Camera in the EnXLosure. Remix that adds vents and allows for use of USB-C cables

Ocena
0 / 5
Polubienia
18
Pobrania
90
Wydruki
1
Wyświetlenia
841
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

To mount an ESP32 Camera to the inside of the Prusa EnXLosure.

This is a remix of Voxel3D's great original design, which didn't work for me as my ESP32-CAM module uses a USB-C cable and none of my cables fit through the cutout of the model. I also added some ventilation slots, to avoid heat collection from the module's flashlight.

BOM

Printing

No special instructions. No supports needed.

Installation (see original design)

  • Insert brass insert into the first hole on the inside of the front right corner of the EnXLosure “hat”.
  • Place ESP32-CAM module into the Base component (camera oriented toward base and USB connector to the top).
  • Push Front component onto Base Component to cover the ESP32-CAM.
  • Install the assembled module in the front right corner of the EnXLosure “hat” using the M3-8 screw.
  • Insert the USB cable and route it along the right side of the EnXLosure and out the rear.

ESP32-CAM Software

Can be found here. This was my first time using an ESP-32, and I found the instructions for flashing the module and connecting it to PrusaConnect to be straightforward. Make sure Hmirror and Vflip are turned on to get the correct orientation.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.