Taginn sleeve/firework launcher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A rifled taginn sleeve and shell that allow a firecracker to be used in the stead of green gas.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 609
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other 3D Objects for Learning
- Licencja
- Creative Commons — Attribution — Share Alike
Taginn 40mms are great fun. Only problem is you use green gas or propane, or hpa or something else. This allows you to use a firecracker in the stead of gas propulsion- you also get the smoke and really fun thoomp sound when launching things.
As firecrackers are fairly weak at lifting heavier loads, it would be recommended to use the paladin chalk projectiles by Die_Bastelkammer (https://thingiverse.com/thing:5190282)
for the light and airy practice projectiles. Electrical tape serves well as a gas seal, but take care with these as the firecracker likes to break the base of the shell before it leaves the sleeve. beefy bases are recommended
Print this at 100% infill for best results- PLA+ is never a bad idea with these things.
I have not tested these besides the firecrackers, so using primers or blanks may not be wise.
Stay safe, stay frosty.