1 / 5
xTool F1 Exhaust Duct Adapter and Internal Fan Spacer (4in) — zdjęcie 1
1 / 5

xTool F1 Exhaust Duct Adapter and Internal Fan Spacer (4in)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replace the xTool F1 internal fan and duct cover adapting to 4 inch ducting for routing to a more powerful inline fan.

Ocena
0 / 5
Polubienia
26
Pobrania
305
Wydruki
0
Wyświetlenia
1653
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted to connect my xTool F1 to the inline exhaust system I already had in my shop. I wasn't able to locate one specifically for the F1 so I went ahead and designed and printed one.

This adapter connects to the xTool F1 and allows a connection to a 4in exhaust hose and features a lip to help secure the hose to the adapter.

I printed it in PETG but I think PLA would preform just as well in a stationary environment.

Installation
  1. Remove and disconnect the internal fan tucking the wire out of the way (optionally, you can cover the connector with electrical tape)
  2. Replace with the Internal Fan Spacer
  3. Install the Flange Duct Adapter using the same screws you removed in Step 1
  4. Disable the internal fan warning in XCS

Inspiration for this model came from @GizmoGoody with a similar adapter for the xTool P2 shared here: https://www.printables.com/model/883905-parametric-xtool-p2-exhaust-duct-adapter-and-inter

Thank you!

NOTE: This is for the original xTool F1 NOT the F1 Ultra

Tagi