Meshtastic enclosure: Heltec V3 and Heltec Tracker

The enclosure is designed for the Heltec V3 or Heltec Tracker. The bottom part of the enclosure is common to both variants. The enclosure is sufficiently dimensioned for a 26650 battery. Both parts hold together by self-clamping.

https://meshtastic.org/docs/hardware/devices/heltec/?heltec=v3
https://meshtastic.org/docs/hardware/devices/heltec/?heltec=tracker

Assembly Instructions:

• Print both parts and the button.
• Screw on the antenna connector.
• Connect the antenna cable to the Heltec device.
• Insert the button into the front part.
• Place the Heltec device into the enclosure - the part is designed to fit snugly enough to hold the device securely in place.
• Attach the battery holder to the back part of the enclosure with double-sided adhesive tape, making sure not to interfere with the space for the antenna connector.
• When the enclosure is closed, the 26650 battery should rest directly on the battery connector of the Heltec device. Support the other side of the device with a few millimeters of soft material (fine foam).
• The soft padding should secure the rear part of the device against falling out, while the front part is secured by the USB connector.
• Carefully slide both parts of the enclosure together.
• If the parts do not fit perfectly, the battery cable has likely gotten between the joints. You can secure it in the back part of the enclosure with a piece of soft, flexible material (fine foam).
• It is not necessary, but the enclosure is ready for screwing together - an M3 nut intended for plastic can be embedded in the front part.