CyberPower ST425 UPS Shelf for Primex Media/Network Cabinet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shelf for small CyberPower UPS in Primex cabinet
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to have a little UPS for my modem, router and switch in my Primex SOHO Pro P3000ND media cabinet that is in the closet under my stairs where all the network cables in my house meet. This should fit the P2100ND and P4200ND as well. I do have the deep cabinet with 1" extension and that is required for this to fit. The UPS I went with is the Cyberpower ST425 which is a nice fit and has 4 battery backup outlets and 4 that are just surge protected. I printed this in ASA because it does get fairly warm in the cabinet but ABS and PETG are definitely options also. PLA may hold up too depending how warm your cabinet gets. I printed this with 5 top/bottom and 4 perimeters and 10% infill. You can enable or paint two small supports on the small round pegs but depending on your printers cooling, you may be fine without them.
