(v2) Project Babble snap-in case for Meta Quest 3

Project Babble is an open source mouth tracking project designed to work with any VR headset.

This is Version 2 of a case I designed to hold an ESP32-CAM, camera, battery, TP4056 charging board, two or more LEDs, and voltage regulator circuit. It can host a complete Wireless Project Babble setup in a small footprint. It's meant to clip to the front of the Quest 3. Insert it into the faceplate crevice and then hook to the nose bridge (see pictures). 

Just assemble all the electronics and place them inside. Mount the LEDs and camera using hot glue. Depending on printer or filament used the lid might not stay in place unless you use some there too. I'm really bad at 3D modeling so you are encouraged to remix and improve on it as long as you credit me. 

Get your electronics for cheap on Ali or use this for reference to buy somewhere else:
· Camera (choose 120º or 160º night version): aliexpress.com/item/1005004578163738.html
· ESP32-CAM (choose ESP32-CAM-MB): aliexpress.com/item/1005006230673407
· Silicone wire (choose 28AWG and your preference of colours): aliexpress.com/item/1005006350734418.html
· TP4056 type C charging board: aliexpress.com/item/1005005341202402.html
· Power Switch (I had these already, could be smaller tho): aliexpress.com/item/1005002781426679.html
· 4x 3.7V 820mAh 653042 LiPo Battery: search B08HJ53Q3C on your local Amazon (one of these should give you ~4h of continuous use, maybe more)

Printing recommendation:

Can be printed in PLA but PETG recommended due to better thermal properties, print standing or sideways with supports. Lid can be printed flat, needs no supports.

License: CC BY-NC