Mini Vault
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a fun project for any sized printer
- Ocena
- 5 / 5
- Polubienia
- 497
- Pobrania
- 973
- Wydruki
- 17
- Wyświetlenia
- 9764
- Oceny
- 15
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed to be printed on the Prusa Mini! (and bigger printers). The box is 6.25" x 6.25" x 4.25".
This design is fully 3D printed with the exception of a single skateboard bearing. No support material is required. Watch the video for full assembly instructions.
There are 2 version of the “Gear8Teeth” with varying levels of tolerance. I recommend printing the ‘NORMAL’ version and test it. If it is too tight, print the ‘LOOSE’ version. It is only a few grams of filament and it should print quickly.
Below is a link for the bearings I used. Note: This link is active as of June 2024, but be sure to verify the bearings you purchase are 608-2RS Skateboard Bearings (8mm x 22mm x 7mm)