Magnetic Hydration Pack Hose Clip. Parametric!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple magnetic clip for keeping your hose attached and in reach. Fully parametric using OnShape
- Ocena
- 5 / 5
- Polubienia
- 137
- Pobrania
- 262
- Wydruki
- 3
- Wyświetlenia
- 1701
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Handy little magnetic clip to keep your hydration hose close at hand at all times!
I've provided files for a couple different strap widths here, but the design is parametric, the OnShape project is included below. I used a 10mmx3mm magnet. I wouldn't recommend going smaller, but larger should be fine.
I printed in PETG with 100% infill for flexibility and durability. The magnet can be glued in, but I've had good success with a friction fit using carful clearances.
-Support: I printed will with no support. Depending on printer settings, you may need to support the top edge of the magnet rim on the hose clip.
-Orientation: Print strap clip flat on its back, hose clip should be printed on its side, pay attention to the flat face
The OnShape model can be found here:
To make your own versions for specific magnet sizes or equipment dimensions (hose diameter, strap width, etc), use the variables table (in the variables tab or the popout side bar on the right). Picture includes instructions for those that are not familiar with onshape.