Airsoft Chiappa Rhino Dummy Suppressor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Integrated Dummy Suppressor for the Airsoft Chiappa Rhino One version for a tracer inside, and another empty one
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 832
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
An integrated suppressor for the Airsoft Chiappa Rhino.
One version for tracers (Brighter R or CS) and an empty version for foam.
You will need:
2x M3x40 Screws ISO4762
2x M3 nuts
1x Spring that fits around the barrel (Further details under assembly)
You will need the pin and grub screw that the original barrel is attached with.
Printing:
For the shell, you will need to implement a filament change, to stop the print right after the hexagonal spots for the nuts are finished. Then while printing, once the printer stops, insert the two nuts. (I dabbed a tiny bit of super glue on the outside, but fitment is already tight)
The base can be printed as is
Assembly:
For the barrel you will need to find a spring that fits outside the barrel. (ID 9mm, OD 11,5MM)
Mine is cut to 30mm, but yours might need to be a bit longer. Make sure that it presses the hop unit backwards, and seals against the cylinder when the front is on. Make sure to adjust until the pressure is just right.
BE AWARE: I converted a 50DS, but had to cut a sizeable bit of the innerbarrel. 40DS and 30DS might work, but haven't been tested.
Other than that, assembly is the same as the OG barrel, and the M3 screws to attach the shell go left and right of the revolver frame.