Vertical Hydrometer Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the Hydrometer mount that clips to a sterilite lid, but is visible from the side rather than the top.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This version will fit the same hydrometer as the original model, below is a link to the ones I used. This model will hang vertically from the lid and show on the side of the container instead of at the top of the lid. Since I was storing mine on a shelf above my printer I was unable to see the sensor read out on the lid.
Print in PLA or anything you like, I suggest organic supports on the lip of the clasp and the squares on the holder. This will make sure they are the correct size and the organic supports are easier to remove. I printed mine with 0.2mm quality setting but another setting should work fine.