Apertura Carbonstar 150 - Dew Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple dew shield to fit on the new 6 inch Newtonian Telescope - Apertura Carbonstar 150.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 193
- Wydruki
- 1
- Wyświetlenia
- 1083
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple dew shield to fit on the new 6 inch Newtonian Telescope - Apertura Carbonstar 150.
Printer calibration ring included for a quick test to verify fit. If the calibration ring is too tight or lose, resize until it fits just right. Then resize the dew shield by that same amount (in X/Y, Z not needed). The dew shield is designed for a snug fit on the aluminum edge of the telescope. Knobs are optional but I like them :)
Might require a bit of sanding inside on the section where it slides over the telescope edge but it really depends on the printer and material.
Printed in ABS and shrinkage is considered in the design. If using other materials, do print the calibration ring first and slide that over the telescope.
The knobs are designed for M4 bolts/nuts.
Painting the inside mat black or flocking is highly recommended.
Printing orientation should be top side on the print bed (it should be obvious from the shape, the one that's not rounded, goes on the bed).
Feel free to ask for any design changes/variations. I will also share the design files a little later down the line.