Obutto Virpil T-50 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount that allows to use a Virpil T-50 base in a center or sidestick mounted configuration on Obutto oZone…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a mount that allows to use a Virpil T-50 base in a center or sidestick mounted configuration on Obutto oZone and R3volution gaming cockpits.
My personal one is the newer revision printed in XT-CF20 with the settings below, works pretty damn well. Still a little bit of flex, but nothing that affects precision.
Print Settings
Printer:
E3D BigBox Dual
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
50% Honeycomb
Notes:
Works even in PLA with good honeycomb infill of 50% and 6 layers for top and bottom, 6 permimeters with a 0.4mm nozzle. Stronger materials like Nylon, Copolyesters and Carbon Fibers are strongly recommended as every increase in strength makes the mount more rigid and less wobbly.
Recommend to print in a sideways orientation so the stresses of usage are not acting in a way that would cause layer separation (see pictures).Post-Printing
After printing, clean out the drill holes with drills and/or reamers, you will need 4, 4.5, 5 and 5.5 millimeter drills. Optionally, use longer M4 hex screws for the bottom holes of the stick for the bigger version.
Only ream holes with a 5mm and 8.5mm drill for the lightweight version and use the included original screws.
Category: Computer