Obutto Orbweaver Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This are parts to enable mounting an adjustable platform to the vertical piping of an Obutto home cockpit. Used in…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 314
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This are parts to enable mounting an adjustable platform to the vertical piping of an Obutto home cockpit. Used in this instance to mount an Orbweaver next to a throttle, made for Star Citizen so one can use proper flight and FPS inputs at the same time and transition blindly between them, very well suited for VR.
When not in use, simply pull out platform upwards and the rest of the assembly can be stuck under the Warthog throttle platform.
Print Settings
Printer:
E3D Bigbox Dual
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.20mm
Infill:
30%
Notes:
Settings depend heavily on the used material, anything which doesnt bend too much will do. Depending on printer's precision (or lack thereof) it may be necessary to tidy up the hole where the platform goes through, it is an intentionally tight fit.
Recommend 5 solid layer on top and bottom as well as 5 solid outer shell lines.
Fixings you'll need:
M4x60 screws (2pcs)
M4x25 screws (4pcs)
M4 locking nuts (6pcs )
Washers (optional)
Printed in both PLA and E3D EDGE, works fine.
Category: Computer