Stages SB20 Bottle Relocation Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bracket to relocate the water bottle holders for a Stages SB20 smart bike. It moves the bottles a few inches…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 138
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a bracket to relocate the water bottle holders for a Stages SB20 smart bike. It moves the bottles a few inches forward and up so you don't have to bend quite as far to reach them, great if you set the bike up in a more upright position.
I printed on the rear edge as shown in the screenshot, with a brim and custom supports under the larger screw boss and interior boss channel. I used 100% infill to make sure it was strong enough, but it might be fine with less.
The factory screws are used to mount the bracket to the frame, and then I used M4-0.70 screws to mount the bottle holders to the bracket. Screw lengths were M4x6mm for the lower hole closer to rider, M4x10mm (with 3 M4 washers to prevent screw from digging into bike frame) for the upper hole toward the front of the bike. I was able to tap the plastic holes for M4-0.70 successfully
Print Settings
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100%
Filament: Hatchbox PLA
Black
Notes:
Ender 3 V2 Neo
Category: Other