Spiderman Web Shooter (BETA MODEL, WORK IN PROGRESS)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spiderman Web Shooter (BETA MODEL, WORK IN PROGRESS)
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 137
- Wydruki
- 0
- Wyświetlenia
- 1085
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Cosplay & Costumes in general
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my interpretation of spiderman's web shoooters from the movies. Beware this is a BETA MODEL! I printed with no supports and a 0.2mm layer height.
To assemble, take the strongest pen string you have and glue it on the bullet
glue a piece of dental floss or thin string to the end of it (around 1.5 to 2 ft).
then take the base, put it on the printer bed after letting it heat up to 75 degrees
put the base on your wrist and warp it around your wrist and redo or repeat as many times as needed
make sure to leave enough space between the 2 sides of base for your wrist to slide through the gap
load the string through the hole in the cartridge and place it in the base
to load the bullet, push it into the hole, pull down the lever and compress the spring until it goes past the notch in the lever, then release the lever and you're ready to fire
To fire just aim and push down the lever.