Wireframe Xmas Tree

• maybe a little early, but you never know when inspiration hits :D
• found a large steel wireframe tree in some random home decoration catalogue and decided to make it smaller and printable
• prints in multiple parts, support free
• I sized it to fit my prusa i3 mk2 print bed (200x250mm)
• parts snap together with half-lap-joints for easy assembly and strength
• a little bit of glue might be needed, depending on your print result
• final assembled height is 45cm/17,7 inches
• I used a 5m/16ft long strip of LED-fairy lights to wrap around the tree approximately twice
  (something like this https://www.amazon.com/YIHONG-Twinkling-Battery-Operated-Festival/dp/B071F4T9F9/ref=sr\_1\_2?s=books&ie=UTF8&qid=1508676334&sr=8-2&keywords=led+fairy+light)
• it looks even better than expected, and is a quick and easy print (<4h)
• you could also hang some ornaments onto the tree
• model units are [mm]
• print every model once, and "Base2" twice

Print instructions

Category: Decor Print Settings

Printer Brand: Prusa

Printer: Prusa Mk2

Rafts: No

Supports: No

Resolution: 0.2

Infill: low

Notes:

• 2 perimeters
• 4 top/bottom layers
• printed in DasFilament black PLA