Red Sea ReefATO+ Pump Stabilizer (ReefCan Compatible)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Collar which slips over the Red Sea ReefATO+ pump and prevents it falling over. Compatible with Red Sea's ReefCans.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 125
- Wydruki
- 1
- Wyświetlenia
- 449
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My new aquarium came with the Red Sea ReefATO+ automatic top off system, and for the fresh water reservoir, I decided to use one of the new ReefCans. When setting up the system, I immediately noticed that the pump has a tendency to fall over quite easily. I came across Zerodameaon's model, which looked like a good solution but which was too large to fit through the access ports on the ReefCan.
Thus, this model was born. I designed it to fit snugly over the rubber cap on the bottom of the pump so it stays in place when placing the whole assembly into the desired location (e.g., the bottom of a ReefCan) and when lifting it back out. And of course, it fits through the ports on the ReefCan without difficulty.
I printed mine with Prusament PLA (in Red Sea … I mean Lipstick … Red) with 0.2 mm layers and 15% infill. (The PrusaSlicer “0.2 mm SPEED” setting is perfect.)