GHL Mitras LX7 to AquaIllumination HMS Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to permit attachment of a GHL Mitras LX7 light to the Hydra Mounting System from AquaIllumination
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printing Tips
I used Prusament PLA in Jet Black, which looks very good with the black Mitras fixtures I have. The model files I've uploaded include the settings I'd recommend: I used Prusa “0.20mm QUALITY” with a couple of modifications:
- Vertical shells: 4 perimeters
- Horizontal shells: solid layers 5 for top AND bottom
- Infill: 20% (gyroid)
These settings produce a light but strong and stiff piece.
Required Items (per Mitras fixture)
In addition to printing two standoffs and one adapter for each Mitras LX7, you will need two 45 mm long M4 x 0.7 mm screws to attach the adapter to the Mitras LX7. (Stainless steel screws such as these from McMaster-Carr are recommended.) Finally, you will need one of the following options:
HMS Single Arm Kit (this includes the mount bracket set needed)
OR
HMS Tank Mount Rail AND 1 HMS Hydra Mount Bracket Set
Note: If you want to mount all your Mitras fixtures on one rail, you obviously only need one rail in total. However, you will need some way to hang or mount the rail, and you will need 1 Mount Bracket Set per light. If you go that route, everything you need is on this page.
Assembly Instructions
Push the long M4 screws through the outer holes on the bracket, then slip the standoffs over the screws. Remove the protective plugs from the mounting screw holes on top of the Mitras fixture, then attach the bracket to the fixture using those same holes.
To attach the entire light assembly to the AI HMS, you will need the hex nut, nylon washer, and short center screw from a HMS Hydra Mount Bracket set. Push the short screw up through the adapter, then add the washer and the hex nut. Spin the nut on about half way, then slide it into the HMS arm or rail. Tighten the screw using the hex key that comes with the HMS kit.
Final Comments
In the photos, you'll notice that I'm using clear standoffs: these are from the GHL Mitras Flex Mount kit, which I bought but which turned out not to work with my aquarium stand. The clear standoffs look great, but as the kit costs $150 US, I included printable ones you can make yourself for pennies.
As you can see, these mounts have received the seal of approval from my cat Freyja.