1 / 9
Smart Orbiter 3 MGN12H and fan duct — zdjęcie 1
1 / 9

Smart Orbiter 3 MGN12H and fan duct

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a really minimal WIP mount for the Smart Orbiter 3 on an MGN12H rail.

Ocena
0 / 5
Polubienia
8
Pobrania
74
Wydruki
0
Wyświetlenia
696
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This should work for any application needing to mount an extruder with the same pattern as the Smart Orbiter 3 to a 20X20mm bolt pattern MGN12 rail.

Belts wrap around the base plate and use clips or any other fastener to hold them. 

Print one of each piece and mount the MGN12 Plate with the belt grooves to the MGN rail and the So3 mount to your SO3.

It uses 97171A310 inserts from Mcmaster as I had them lying around so I cut them down flush after inserting. The flange is on the side facing the Orbiter on mine. 

The screws are 90236A120 also from Mcmaster with 8 being used. Any M3 can be used on the outermost holes to screw into the brass fittings and I intend on mounting other attachments to those with longer screws. 

Uploading my files for the fan duct and .f3d of the project. I will likely not be messing with this any longer until I can put my Ender 5 Plus back together (cross country move)

I ran this setup on my E5+ for quite a while before the move and it worked great. 

The Duct main body can accept any air you can adapt to it so stuff like cpap or in this case dual 5015 blowers.  

Added BL-Touch mount as well Offset is 20mm in front of the nozzle center point.

Part cooling nozzle is from a VZ bot 370

Tagi