Bambu Top Filament Mount to accommodate led riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
re-mix to accommodate body panels/LED riser.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 199
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I am sure I am not the only one who cannot easily access the rear of their X1C/P1C printers. I found the linked file but it was designed to work for the P1P which does not have the rear body panel or LED riser.
I have installed the LED riser found here - (https://makerworld.com/en/models/81856) one disclaimer - I used only the print files for the riser - I did not use the LED's they recommended - I used the ones from Bambu found here (https://us.store.bambulab.com/products/6500k-white-led-light-strip) that plug into the available USB port on the P1S/P1P.
This called for extending it 5mm for the body panel and 21mm for the LED riser - total additional extension of 26mm. Due to this additional height the PTFE tube did not easily line up so for the current printed ones I simply increased the length of the PTFE tube and looped it as seen in the pictures. I plan to modify this further, when I have time to simply connect to the existing PTFE tube under and to the left side of the spool holder. For now, I have run 3 rolls of filament thru the current set up with no issues on 3 separate P1S printers.
note: I replaced the existing 2 body screws with M3x16mm screws to hold the spool holder against the printer and 2 M3x6mm screws to hold the top piece over the PTFE tube.
Any questions, just let me know!