Block Plane Holder for IKEA Skadis Board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for storing your block plane on a Skadis Board. Designed to protect the plane iron from scuffs and damaging.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
The problem with block planes is you have to store them right to prevent the plane iron from being damaged. I don't want to retract the iron everytime I put the block plane aside. Therefore I put the block plane on the side and made sure I would not tumble it over and possibly scuff my iron.
As I use the Skadis Pegboard in my workshop I was looking for a suitable solution for this problem. There are tons of holders out there but nothing would suit my needs. So I made one from scratch.
The holder is designed for my Juuma block plane. It will fit many others. The block plane lies in a recessed area and won't slip off. More important: the blade iron can't be damaged as I made a deepening on both sides of the support surface. This way the orientation you put the block plane on the holder doesn't matter.
Printed in PLA with 0.24 layer height and 0.4 width. I used 25 % Gyroid infill. Make sure to print lying flat on the back (the side that goes to the pegboard). No support needed this way.
The whole thing is super sturdy and will last forever I think. To put it on the Skadis Board I used 4 of the infamous universal hooks by CSD_Salzburg. Still my favorite mounting system. The hooks were printed in PETG as I do with all my hooks.