Aqara U200 Lever Handle Spacer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adjustable spacer to fill the gap around a Euro Lever Handle.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 242
- Wydruki
- 1
- Wyświetlenia
- 1804
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
My handle has 92mm centres (spindle to lock centre) and is the type where the top screw is below the handle.
My handle's dimensions are 32mm wide, 11mm deep and the bottom of the handle is 79mm from the lock centre.
To adjust, open the f3d file in Fusion 360, in the ribbon, click “Modify” → “Change Parameters”
There are 3x 4mm holes that are intended to receive melt-in brass thread inserts. The upper two would require drilling the back plate of the U200. The lower one should line up with an existing hole. You could reduce the spacer thickness and just use the adhesive sheet.
I printed with 0.4mm nozzle, 0.2mm layers, 20% cubic infill, and 4x walls( to provide good support for the brass inserts).
Update:
Modified so that the upper holes don't move with handle width changes