1 / 10
OpenDTU Socket Outlet Enclosure
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Slightly over-engineered housing for OpenDTU which could be plugged directly to socket outlet (EURO-/ SCHUKO-plug).
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 637
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a special case for the OpenDTU breakout board by blinkyparts.com which could be attached directly to a socket outlet (SCHUKO)
Printing instructions
Backside
- Material: PLA, PETG, …
- Perimeter: 2
- Infill: 15%
- Supports: yes, I used organic support.
Front cover
Should be printed with front side on the bed.
- Material: PLA, PETG, …
- Perimeter: 2
- Infill: 15%
- Supports: no
BoM
| Quantity | Name | Picture | Link (example, no affiliate) |
|---|---|---|---|
| 1 | OpenDTU Breakoutboard by blinkyparts.com |  | https://shop.blinkyparts.com/en/OpenDTU-Breakoutboard-Your-evaluation-for-your-balcony-solar-system/blink237542 |
| 1 | USB power supply unit |  | https://amzn.eu/d/0igDwA8U |
| 1 | USB Cabel |  | https://amzn.eu/d/02PisvVq |
Assembly
- First place the OLED-Display within the cover. See pictures.
- Connect the display and the circuit board with the cables
- Attach USB-C cable to circuit board
- Clip the circuit board together with antenna board attached within the case. Pay attention that the LEDs are placed correct in the wholes. maybe you have to adjust them.
- Pass external antenna through the whole and screw it on the base.
- Push USB power supply in back element. Should be a little bit tight.
- Attach USB-A of cable to the power supply.
- Do a short test by plug in power socket and check if everything works and is connected correct.
- At last step push backside into back of front part. It should snap in.