1 / 2
VOG-17 VASE Mode Accessories — zdjęcie 1
1 / 2

VOG-17 VASE Mode Accessories

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Various models to support the use of VOG-17

Ocena
0 / 5
Polubienia
15
Pobrania
445
Wydruki
0
Wyświetlenia
1582
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

These are models based around the use of the VOG-17 
Based on the most common tail fin design ive developed some improvements and training aids. 

I've long believed VASE mode prints are good for far more than vases, if done right they are stronger faster prints, many of these models use experimental methods to trick the slicer into doing interesting things. I'm afraid you'll have to slice them to see how they work. 

VOG 1
Is a straightforward model of a VOG-17 with the most common fins built in, 
for printing in non vase mode as a desktop ornament only, try with colour changes. 

VOG 2 
Is intended as a desktop model printed as a single piece in VASE mode, making it much faster. To make this possible i've designed a new type of tail that can be printed in either orientation, 
Print nose down, brim, with a few bottom layers. 0.48-0.6 extrusion width 
Don't print too fast if your using a bed slinger as its top heavy 

VOG 3 
Is the standard tail being added to VOG-17 grenades but modified to allow it to be printed in VASE mode, potentially allowing them to be churned out much faster. 
0.6 extrusion width.

VOG 4
Is a new design for a tail fins for the VOG-17 which can be printed in VASE mode in either orientation 
0.6 extrusion width.

VOG 4a 
As design 4 can be printed in either direction they can be stacked on top of each other, 
i have designed this to print two together, they'll snap apart easily post printing.
0.6 extrusion width.

VOG 5 
Is designed as an inert training grenade, 
Both parts are printed as vases (0.6 extrusion with bottom layers) 
The tip can then be filled with sand/flour and the tail is glued in. 
Making a cheap and disposable training aid. 

VOG 6 
A VASE mode spin stabilized tail design based on a previous model of mine, it should achieve the desired effect with less weight / filament
 

VOG 7 
A VASE mode tail design designed for 0.4mm extrusion for low weight and simplicity 
uses hollow sections to add rigidity 

VOG 8 
Not a practical design ill admit but uses an interesting vase technique to mimic the box style tail of older bomb tail designs. 

VOG 9 
A VASE tail design. Designed to produce the maximum drag stabilisation for the minimum filament, the design produces single wall fins while the others are are all double surfaces. 
it deliberately has allot of surface area to stabilize a drop quickly, many of the basic minimal fins in use are only effective once moving at high speed.  
(0.48 extrusion width)
 

Tagi