Generator Plug, Charging Cord
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wire tie that slides together using a 45° dovetail that is 3D-printable without supports. Holds two 5mm wires…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 72
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
A wire tie that slides together using a 45° dovetail that is 3D-printable without supports. Holds two 5mm wires together securely such that they may be used for experimental purposes and not short out against each other. Used to create a makeshift blade plug to fit a 12-volt generator with an odd socket. Not approved for mains voltages. But the design could be remixed or tweaked to fit other wire sizes. Fashion arbitrary types of plugs or wire holders that do not require screws or other types of hardware, or tools.
Print Settings
Printer:
Geeetech A10T
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
50%
Filament: Prusament PETG Black
Notes:
PETG for outdoor use
Category: Electronics