Neptune 4 Plus Build Plate Aligner; Supports Cable Chain

This is a build plate aligner for Neptune 4 Plus. Installs in the rear left corner of the bed. Allows attachment of cable chain parts to the bed cable (optional). Uses the original screws. Unscrew and remove the cable retainer plate, screw in this aligner. Done.

This is a tight fit, but worth it as the build plate aligns with the bed easily and effortlessly.

I have only modified the heatset insert version. If you need another version modified, let me know.

I assume this will work with Neptune 4 Max. Once I test on a Max (in the next few days likely) I will update the title and description. If further modifications are needed for fitment on the Max, I will make them and upload the model to this listing.

This does NOT fit Neptune 4 Pro or Standard. For those, see the original model or my other remix of the model.

Based on the model by @Joushou_1339808, modifications to allow fitment on Neptune 4 Plus have been made.

• Shifted holes and studs left ~2mm by cutting off excess
• Moved holes and studs toward back edge ~1mm
• Elongated the raised bed stops by a couple mm on each side
• Slightly lowered the bed contact shelves for better fitment

For more information, see the original model details.

Update 20240623: My pictured test unit fit perfect on one N4Plus, but would not fit on another. I've shifted the mounting holes and pegs ~0.15mm. This should allow for enough play for a good fit while also ensuring well-aligned build plates. I've also made a little more front-back room for the plastic ziptie holder piece to move which may help in screw hole alignment.

UPDATE 20240802: Added version for smaller heatset inserts. Most inserts are 4.7 to 5mm diameter and should fit well in the standard REV2_5mm model. if your inserts are closer to 4.5mm you can try the smaller hole REV2_4.5mm version.